Podrobnosti záznamu

Název
    Thickness of cap rock and other inportant factors affecting morphogenesis of salt karst
Údaj o odpovědnosti
    Jiří Bruthans, Jakub Šmíd, Michal Filippi, Ondřej Zeman
Další názvy
    Debelina krovnine in drugi pomembni dejavniki, ki vplivajo na morfogenezo krasa v soli
    Papers presented at 8th International Karstological School "CLASSICAL KARST - COLLAPSE DOLINES", Postojna, June 26-29th, 2000 (Variant.)
Autor
    Bruthans, Jiří
    Filippi, Michal
    Šmíd, Jakub
    Zeman, Ondřej
Jazyk
    anglicky
Zdrojový dokument - seriál
    Acta carsologica
Svazek/č.
    Vol. 29, no. 2
Strany
    p. 51-64
Rok
    2000
Poznámky
    3 obr., 4 fot., 12 bibl.
    il.
    Zkr. název ser.: Acta carsol. (Ljubljana)
Předmětová skupina
    cap-rock
    dolina
    eroze
    evapority
    hydrologie krasová
    koroze
    pseudokras
    rozpouštění
Geografické jméno
    Irán
Klíčové slovo
    Affecting
    Cap
    Factors
    Inportant
    Karst
    Morphogenesis
    Other
    Rock
    Salt
    Thickness
Abstrakt (anglicky)
   Four classes of different thickness of cap be distinguished, each with its special superficial and underground karst forms: 1. salt outcrops, 2. thin cap rock (0,5-2 m), 3 cap rock of moderate thickness (5-30 m). The most important factors affected by cap rock thickness are as follows: the density of recharche points, the amounts of concentrated recharge which occur at each recharge point, the rate of lowering the ground surface of salt karst, the dissolution capacity of water and the size and amount of load trasported by underground flood-streams into cave systems. The thickness of cap rock in the recharche area of the cave and the type of recharche into the salt environment. Another important factor is the thickness of overburden above the cave, which negatively correlates with intensity of breakdown.
   Wide passages in some caves are developed as result of intensive deposition of bedload, which expel the stream into the side of the passage and are due to enhanced corrosion in the few decimetres high zone above the bottom of passage
Přispěvatel
    Česká geologická služba
Kód přispěvatele
    ČGS (UNM)
Zdrojový formát
    U
Datum vložení
    16. 8. 2007
Datum importu
    8. 8. 2012